Description
Single Pulley for 1/2 Inch Belts
Specifications:
- 2 3/8" (2.36"), 66 mm OD pulley for wide 1/2" belts
- Gold zinc plated
If you have a problem with your PMA overheating it may be a slipping belt causing the problem. On high amp output, the PMA or alternator is under a large load and starts to overheat when the belt begins to slip. That's why high amp PMAs or alternators use dual belts.
This fan and pulley is used on our PMAs when using a gas motor or hydro, a must for keeping your PMA cool! Allowing your PMA to overheat will cause it to burn out. A fan and pulley are not necessary when the PMA is being used for a wind turbine.
Related Products
80 mm Single Pulley
Missouri Wind and Solar
€23,00
Single Pulley for 1/2 Inch Belts
Specifications:
3 1/8" (3.14"), 80MM OD pulley for wide 1/2" belts
If you have a problem with your PMA overheating it may be a slipping belt causi
Fan & 66mm Single Pulley for PMG/PMA
Missouri Wind and Solar
€30,06
Fan and 66mm Single Pulley For Permanent Magnet Generators/Alternator
A large extra heavy duty cooling fan must be used for all
Fan and 80 mm Single Pulley for Permanent Magnet Generators/Alternators
Missouri Wind and Solar
€44,79
Fan and 80 mm Single Pulley For Permanent Magnet Generators/AlternatorA large extra heavy duty cooling fan must be used for all engine, hydro, and or belt driven systems including vertical axis wind...
80 mm Double Pulley for ½ Inch Belts
Missouri Wind and Solar
€20,77
Double Pulley for 1/2 Inch BeltsPulley Specifications: For permanent magnet alternators with 17mm shaft Pulley fits 1/2" beltsGold zinc plated If you have a problem with your PMA overheating it may...
