Description
Single Pulley for 1/2 Inch Belts
Specifications:
- 3 1/8" (3.14"), 80MM OD pulley for wide 1/2" belts
If you have a problem with your PMA overheating it may be a slipping belt causing the problem. On high amp output, the PMA or alternator is under a large load and starts to overheat when the belt begins to slip. That's why high amp PMAs or alternators use dual belts.
This fan and pulley is used on our PMAs when using a gas motor or hydro, a must for keeping your PMA cool! Allowing your PMA to overheat will cause it to burn out. A fan and pulley are not necessary when the PMA is being used for a wind turbine.
Related Products


66 mm Single Pulley
Missouri Wind and Solar


80 mm Double Pulley for ½ Inch Belts
Missouri Wind and Solar


Fan and 80 mm Double Pulley for Permanent Magnet Generators/Alternators
Missouri Wind and Solar


Fan and 80 mm Single Pulley for Permanent Magnet Generators/Alternators
Missouri Wind and Solar
Customers Also Viewed


1600 Watt Freedom Hydro PMG Permanent Magnet Generator
Missouri Wind and Solar


80 mm Double Pulley for ½ Inch Belts
Missouri Wind and Solar


66 mm Single Pulley
Missouri Wind and Solar


Fan and 80 mm Single Pulley for Permanent Magnet Generators/Alternators
Missouri Wind and Solar

7 Magnet Permanent Magnet Alternator
Missouri Wind and Solar


Wind Turbine Shaft Adapter
Missouri Wind and Solar


SkyMax Energy Frontier PMG
SkyMax Energy


2000 Watt Freedom II Hydro PMG Permanent Magnet Generator
Missouri Wind and Solar


Fan and 80 mm Double Pulley for Permanent Magnet Generators/Alternators
Missouri Wind and Solar


Fan & 66mm Single Pulley for PMG/PMA
Missouri Wind and Solar