All In One Sky440 Charge Controller Board with Optional Inverter

Our All in One SKY440 Hybrid Charge Controller Board provides a complete, pre-wired solution for your battery based system. Choose between 12, 24, and 48 Volt pre-programmed options without inverter, or opt for the pre-wired, pre-programmed board with inverter for 12 or 24 volt systems.

Charge Controller Features:

• Dual meters:

• • Each meter displays voltage, wattage, amperage and watts per hour from each charging source.

• Dual microprocessor controlled for stability and accuracy

• Multiple user changeable settings and trip points for many various system requirements and applications.

• • You can change the dump point voltage level, end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)

• Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board

• On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics. No one else has this!

• High amp rating: 440 amps, 10,000 watts; 100 amps continuous for the solar side.

• Can divert the charging source from the batteries to the load or dump both the batteries along with the charging source

• Connect both wind or hydro and solar at the same time

• Reverse polarity protection

• MidNite Solar MNEPV 100 Amp and 63 Amp 150VDC Din Rail Breakers

Optional Power Inverters available for 12 and 24 Volt systems: